Materials Of Construction





VITON® is a trademark of DuPont Performance Elastomers

TEFLON® is a trademark of DuPont Performance Elastomers


Ansi Dimensions

Pool & Spa Valve
1 1/2" - 2 Way and 3 Way Connections
2" -2 Way And 3 WAY Connections

Design Specifications

Thermoplastic Pool & Spa Valves are manufactured for either two way or three way flow direction. Body is one piece. The stem and sealing unit is of the rotary type. The self locking handle makes it easier to use and adjust and the lock ring closure allows quick and easy maintenance without special tools.



PVC, ASTM D-1784 (white)


Rotor Gate, Seal Retaining Plate, Rotor Shaft

PPG, Polypropylene Glass reinforced


Rotor Seal, Rotor O-Ring, Lid O-Ring

EPDM, Ethylene Propylene Diene Monomer





End connectors shall conform to the following standards:



ASTM - D2467 (PVC, SCH-80)



ASTM - D2464 (PVC, SCH-80)


Indenpendent Testing Results


2" - 3 Way Valve
10,000 Cycles under 70 psi water pressure at ambient temperature.
Leak Testing: tests were performed after each 5000 cycles at 70 & 100 psi working pressure at ambient temperature. No Leakage Occurred! Valve was not lubricated during the 10,000 cycles. Valve body was tested at 225 psig water pressure for 15 minutes. Results - No leakage, no structural damage.


Not recommended for compressed air or gas service.