a


 

SAFETY BLOCK BALL VALVE
True Union Type (4")

 

             
Design Advantages
         

• Safely blocks in both upstream and downstream direction for simple easy, safe system maintenance.

• Double union design permits quick, easy piping system installation, removal, maintenance.
• Stem has internal land above ball that is pressure seated to the body protecting the stem and the stem seal from contaminants in the fluid media.
• Long life self lubricated TFE seats are externally adjustable, fully replaceable.
• True full port design has immeasurable pressure drop.
• Valve body can be rotated 360° for actuation clearance in system.
• Handle indicates valve open/close position.
 
• Safety design blow-out proof stem.
• Available in socket, threaded, or flanged (ANSI B16.5 class 150) end configurations.
• PVC safety block ball valves are 4" are available in socket or threaded or flanged ends.
 

• All valves are hydrostatically tested.

•Pneumatic (air to air, air to spring) and electric actuation available. 

 
• All TVI safety block ball valves are backed by our two (2) year guarantee.
• Available locking handles, stem extensions, 2" square nut operation
   
 
 
 
Materials Of Construction
               
                   
 
 
 
 
 
 
   
   
   
   
 
 
   
 
 
 

VITON® is a trademark of DuPont Performance Elastomers
TEFLON® is a trademark of DuPont Performance Elastomers

 

               
Ansi Dimensions
                 
 
 
Testing performed on PVC/PP/EPDM valves at 73°F water temperature, non-shock.
         
Safety Block - True Union Ball Valves
               
                   
Design Specifications
                 

Thermoplastic Ball Valves 1/2" - 3" are designed to safely block full system pressure in either direction to allow on-line system maintenance. Valve stem is of the blow-out proof design. Valve has full port for lowest possible pressure loss. Seats shall be easily adjustable and replaceable. Stem has an internal pressure sealed land to protect stem and stem seal from contaminants. Every valve is fully pressure and cycle tested before leaving the factory. Materials of construction shall be: (select as required for service)

 

Body/Ball/Stem/End Nuts and Connectors

PVC, CPVC, ASTM D-1784
PP, ASTM D-4101
PVDF, ASTM D-3222

 

Seat

PP, ASTM D-4101 (Standard)

 

Seals

EPDM, Ethylene Propylene Diene Monomer
Fluorocarbon. Viton® (DuPont Performance Elastomers)
Fluorel (3M Corp.)

 

T - Handle

ABS, ASTM D-1788

 

End connectors shall conform to the following standards:

 

Socket

ASTM - D-2467 (PVC, SCH-80)
ASTM - F-439 (CPVC, SCH-80)

 

Threaded

ASTM - D-2464 (PVC, SCH-80)
ASTM - F-437 (CPVC, SCH-80)

 

Flanged

ANSI - B16.5 Class 150

Both socket and threaded end connectors shall be supplied on all 1/2" - 2" PVC and CPVC valves. On 2-1/2" - 4" socket end connectors will be supplied unless otherwise specified.

 

Valves shall be backed by a full two (2) year guarantee.

Not recommended for compressed air or gas service.