a


 

WAFER STYLE UNIVERSAL BUTTERFLY VALVE FOR ANSI FLANGES

 

             
Design Advantages
         

• Lower initial cost compared to other valve types.

• Easier installation due to narrow face to face affords lowest installed cost.
• Designed to fit between ANSI D-16.5 Class 150 flat faced flanges.
• Strong, one piece molded body design.
• One piece standard S.S. through shaft for positive disc rotation and support
• Standard polypropylene (PP) disc for higher (180°F) temperature service.
• Full body liner seat with integral flanges (eliminates the need for flange gaskets) ribbed for positive flange seating with minimum required torque.
 
• Standard PVC body and S.S. shaft are effectively isolated from the flow media by the full liner seat.
• Standard S.S., carbon steel plated, or epoxy coated external hardware for added corrosion resistance.
•2" - 8" valves have spring loaded latch lever for positive disc positioning and shut-off.
 

• Electric and pneumatic actuation packages available.

• 8" - 8" valves have epoxy coated self-locking worm gear actuators for ease of operation and accurate flow control. 

 
• Locking handles available.
• Stem extensions, universal joints, floor stands available in a variety of materials.
   
 
 
 
Materials Of Construction
               
                   
 
 
 
 
 
 
   
   
   
   
 
 
   
 
 
 

Viton® and Teflon® are registered trademarks of DuPont Performance Elastomers.

 

         
Ansi Dimensions
                 
 
 

Testing performed on PVC/PP/EPDM valves at 73°F water temperature, non-shock.

 

         
Wafer Style Universal Butterfly Valve For ANSI Flanges
               
                   
Design Specifications
                 

Thermoplastic Butterfly Valves 2"-8" are wafer style to fit between ANSI B16.5 Class 150 flanges. Disc is contoured for lowest possible pressure drop ( highest Cv). Shaft is 410 S.S. and of one piece, through shaft design, with square drive through entire length of blade. 2" - 6" valves shall be complete with a spring loaded 6 position latch lever. 8" valves shall be either spring lever or gear actuated as required or specified. Seat liners shall be full faced with integral, ribbed flanges. No auxiliary gaskets shall be required for installation. Seat liners shall effectively isolate the body and shaft from the flow media. Seat liners shall also thermally insulate the body from the internal operating temperature. Valve liner and seals are replaceable. Materials of construction shall be: (select as required for service)

 

Note: The universal style 2-4" butterfly valve fits between ANSI B16.5, DIN, and JIS class 150 flanges, the 6" between ANSI and JIS flanges and the 8" between ANSI flanges.

 

Body

PVC,ASTM D-1784

 

Disc

PP, ASTM D-4101 (Standard)

 

Shaft

ASTM A-240, TYPE 410 S.S. (Standard) 304 S.S., 316 S.S. available

 

Seat/Seals

EPDM, Ethylene Propylene Diene Monomer
Fluorocarbon, Viton® (DuPont Performance Elastomers)
Nitrile (BUNA-N)

 

Hardware

2" THRU 24" 304 S.S. 8" size positioner plate 410 S.S. Chrome Plated

 

Lever

ABS, ASTM D-1788

 

Gear Box

Cast iron housing ASTM A -53, Epoxy coated

 

Other Materials Available Upon Request

Not recommended for compressed air or gas service.